Dodge Challenger R/T Need some help

[Peter Built]

Hi Guys
I created this Challenger R/T pval plaque and cannot seem to get the shaker hood scoop looking right. Would sure appreciate some help with it. I have attached the pic with measurements and the .dxf file
Peter

CHALOVA1.DXF

[DieselFumes]

Awesome looking file! Do you have the original picture of the car for reference? If so can you post it?

[Larry83301]

You have the prospective wrong on the scoop. You are trying too hard to show the two openings but from where the view is from the opening on the right would show very little. I found a pic that's close but still not quite right (angle to high) should give you an idea of what it should look like.

Hood -2.jpg

Hope this helps.


Larry

[Peter Built]

Hi Larry
Thanks for sending the pic, I can see what you are saying. I'll print this off and see what I can come up with.
Peter

[John Frantum]

I made this a while back, maybe you could use parts of it.

2016 challenger.dxf

[Peter Built]

Hi John
Thank you very much!!! It is appreciated.
Peter