Butterfly Puzzle with 14 ga slots

[plasmajoe]

Here you go Jim as requested. Slots for 14 ga.

Plasma Joe

[ironhorse]

Hey, that's sweet, thanks for posting it.

Greg

[jimjimmac]

Just to let everybody know, I wanted a 3D butterfly with wings that are about 9 inches tall that I could cut from 14 ga.. A 3D butterfly was posted for 14 ga. awhile back, but it was smaller than what I wanted. When I scaled it up to the size I wanted the slots also scaled up so they were no longer the thickness of 14 ga. I sent Joe an email asking if there was an easy solution to making it larger but keeping the slots the same size. He stated that they have to be done manually or have good software to make it easier. He then offered to do it for me. When done, he was going to email it back but I felt that his efforts should be shared by all so I requested he post it on the site.

Thanks Joe, I hope others will be interested in downloading this. Your efforts and contributions are very much appreciated not only in this instance, but in all that I have seen over the past year or so that I have been on this site

Jim

[plasmajoe]

You are very welcome Jim, it was a pleasure to help you out.

Plasma Joe