PrimeWeld Cut60 Settings Chart

Discussion forum for RazorWeld, Everlast, and all other plasma cutters.
Post Reply
AdamE
1.5 Star Member
1.5 Star Member
Posts: 32
Joined: Mon May 29, 2023 7:54 am

PrimeWeld Cut60 Settings Chart

Post by AdamE »

Simple chart to help with STEEL cut settings not listed in the PrimeWeld manual. These may not be the optimal settings for you, but will be a great place to start to further dial in to perfection. .PDF file attached
PrimeWeld Cut60 cut settings chart.png
PrimeWeld Cut60 Amp vs IPM.pdf

You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here

kicktillmonday
2.5 Star Member
2.5 Star Member
Posts: 163
Joined: Tue Aug 30, 2022 9:34 am

Re: PrimeWeld Cut60 Settings Chart

Post by kicktillmonday »

Great looking chart, I will give it a try and see if i have better luck, I was cutting everything at WOT.
DIY 4x8 table
Powermax 65
AdamE
1.5 Star Member
1.5 Star Member
Posts: 32
Joined: Mon May 29, 2023 7:54 am

Re: PrimeWeld Cut60 Settings Chart

Post by AdamE »

kicktillmonday wrote: Mon Feb 05, 2024 12:17 pm Great looking chart, I will give it a try and see if i have better luck, I was cutting everything at WOT.
A good visual always helped me so i figure i cant be the only one, thanks. The values are (for the most part) interpolated from the settings chart primeweld provides in their manual. Likely wont be perfect but otta be in the ball park.
Awesome
1 Star Member
1 Star Member
Posts: 16
Joined: Fri Jun 07, 2024 4:31 pm

Re: PrimeWeld Cut60 Settings Chart

Post by Awesome »

Thank you. This is very helpful. I'm using a Duramax torch adapter for the Primeweld Cut60, so I was using the Hypertherm settings and wasn't getting good cuts. I'll try this. Looks like my settings were too fast.
Post Reply

Return to “RazorWeld, Everlast, & All Other Plasma Cutters”