Starfire / Ontime AVC168

Hypertherm Plasma Cutter discussion forum.
Post Reply
RobertN93
1/2 Star Member
1/2 Star Member
Posts: 1
Joined: Mon Jun 10, 2024 10:36 pm

Starfire / Ontime AVC168

Post by RobertN93 »

Hi, not my field of work plasmacutting or metal working but im connecting a hypertherm 1850 to an AVC1850 and if i have understood correctly; start is easy, 3 and 4 on the 1850 to J2, 5 and 6 on the AVC168.

But the thing im unsure about, on the 1850, J15 and J16 goes to J1 on the voltage divider board on the AVC168 for height control?

And then from the 1850, where do i put the XFER signal?
weldguy
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 2038
Joined: Fri Apr 17, 2009 11:48 am

Re: Starfire / Ontime AVC168

Post by weldguy »

Are you able to attach the 1850 manual showing J15, J16, etc. In addition the manual for your THC would be great.

Some equipment does not use the XFER signal, would like to see these manuals if you could.
Post Reply

Return to “Hypertherm Plasma Cutters”