Ohmic Sensing with Relay Modules

Linux CNC - Plasmac related questions, tips and topics can be posted here
Post Reply
wonder1
1/2 Star Member
1/2 Star Member
Posts: 1
Joined: Thu Dec 28, 2023 3:08 pm

Ohmic Sensing with Relay Modules

Post by wonder1 »

Looking for some feedback on this wiring diagram for Ohmic sensing using 2 opto-isolated relay modules. I'm using a Mesa 7i96s and a Hypertherm PowerMax 1000 plasma cutter. I based the drawing mostly from the CNC Plasma primer on the Linux CNC website, but redrew it to match the relays I am using. It is working as it should, but wanted to get a second look before I started cutting with it.
Ohmic Sensing with Relay Modules.png
User avatar
acourtjester
6 Star Elite Contributing Member
6 Star Elite Contributing Member
Posts: 8154
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: Ohmic Sensing with Relay Modules

Post by acourtjester »

I have been using a similar circuit with LinuxCNC and other electronics, and it works great. I am using a 7I76E card but I'm sure yours will work the same. They make those modules in different voltages I used 12 volts on mine.
Ohmic sensor 12 volt.JPG
Ohmic relay package (3).JPG
Ohmic sensor Module.pdf
(1.29 MiB) Downloaded 5 times
Ohmic sensor Module.pdf
(1.29 MiB) Downloaded 5 times
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Post Reply

Return to “Linux CNC - Plasmac”