Plasma cam Error message

PlasmaCam Hardware discussion forum
Post Reply
skiwithnoskis
2.5 Star Member
2.5 Star Member
Posts: 122
Joined: Thu Aug 26, 2010 9:12 pm
Location: Ohio

Plasma cam Error message

Post by skiwithnoskis »

I need some help. Today while cutting the machine started acting sketchy. It will cut for a while two three cuts maybe. The i get a cutting signal lost message (may no be the same verbage). I have a good ground and new consumables. If i initialize the machine i will do a few more cuts before giving me the error again. Plasma cam dhc2 and ht 1250

Thanks for the help

BB
Top
Post Reply

Return to “PlasmaCam, Samson, & Go Torch Forum”