Thanks and Hello

For general topics and questions that do not fit into any of the other categories or forums.
Post Reply
danny
2 Star Member
2 Star Member
Posts: 53
Joined: Sun Jun 24, 2012 5:39 pm

Thanks and Hello

Post by danny »

Would like to take a moment to thank everyone on here for all the information I've found over the past several months. and for the shared DFX. files that I've downloaded, (like a spoiled kid in a candy store). As I'm just getting started at this and would have ask a lot of questions if I were a better type'r. the post that I've read have been a god send to me getting my little table going.I will try to post some pic.of the few things we've done

Thanks to all, Danny
MERRY CHRISTMAS
2X2 Shop built table,proma thc,TB6560 bob
TD cut master 52,SL 100 machine torch
mach3, sheetcam, 26cfm compressor, Ref.air dryer, water seperator, motorguard toilet paper filter
Top
Post Reply

Return to “CNC Plasma Cutters General Forum”