height contol bouncing
-
rottenleonard
- 1.5 Star Member
- Posts: 33
- Joined: Sun Nov 20, 2011 10:30 am
height contol bouncing
I'm cutting .060 aluminum and I have an issue with the height control bouncing up and down rapidly as it travels intermitantly, It probably is moving an 1/8" up and down, causing a ruffer edge. Any Ideas?
-
XXTEXX
- 1/2 Star Member
- Posts: 9
- Joined: Mon May 28, 2012 1:21 pm
Re: height contol bouncing
Try faster cutting speed.
-
Craig
- 3.5 Star Member
- Posts: 628
- Joined: Mon Dec 24, 2012 3:43 pm
Re: height contol bouncing
What version of DE are you using? Do you have Advanced Height Control? Have you tried adjusting the "Arc Voltage Shift"?
Craig Johnson
Craig Johnson
-
sled50
- 1/2 Star Member
- Posts: 9
- Joined: Fri Dec 28, 2012 11:52 am
Re: height contol bouncing
We cut a lot of aluminum of various thickness. First make sure you have a good ground from the table to the cut piece. Next check your force when moving setting, make sure it is at least set to 24! I had the same problem awhile back and Brian at tech had me check these. It has been working perfectly since.
