Plasma cam stoping and starting

Rockenjvdesign · Post by **Rockenjvdesign** » Mon Jan 13, 2014 4:42 am

Hi all
I'm haven trouble when I go from cut to cut I have to wait awhile in between cuts I have the dh advanced table with a cut star plasma any ideas if it's my settings or just my cutter?

weldor2005 · Post by **weldor2005** » Mon Jan 13, 2014 8:25 am

Do you have a check box that says pause between cuts marked? This would be in the cut settings, and would make a cut, and move to the next pierce and wait for you to press go again before cutting.

Rockenjvdesign · Post by **Rockenjvdesign** » Mon Jan 13, 2014 1:33 pm

Yes I do if I don't have it checked it still won't fire after each cut

Post by **jimcolt** » Mon Jan 13, 2014 6:48 pm

Some of the import plasma systems will not fire while the post flow cooling air is flowing, so you may have to wait until that times out....or if the post flow is adjustable you may be able to shorten the time.....it will also shorten the consumable parts life.

Jim Colt

Rockenjvdesign wrote:Yes I do if I don't have it checked it still won't fire after each cut

Rockenjvdesign · Post by **Rockenjvdesign** » Mon Jan 13, 2014 9:45 pm

Ok jim ya I think that is it im trying to get me a hypertherm or a milller thank you both

Plasma cam stoping and starting

Plasma cam stoping and starting

Re: Plasma cam stoping and starting

Re: Plasma cam stoping and starting

Re: Plasma cam stoping and starting

Re: Plasma cam stoping and starting