![Wink ;)](./images/smilies/icon_e_wink.gif)
In the .dxf file, there is a five-sided piece that we cut out to serve as a bending guide for the sides (angle was 145 degrees between sides and feet). The notch should be towards the top side. There are bootrail supports included that should match up to the angle of the sides, as well.
**may want to cut and build the sides of pit before cutting out the bottom to insure proper fit. After bending with rosebud, our bottom didn't fit quite as snuggly as intended.
![Image](http://www.plasmaspider.com/images/nature-firepit-dxf.png)
![Image](http://www.plasmaspider.com/images/wildlife-fire-pit.jpg)