tulip sculpture

[ornametals]

these stand about 40" high. made from 10 ga. i put the pistol in the center. weld and ground smooth where the pedals meet the stem. stem is 5/8" rod and go into the ground 2'. takes a bit of forming for leaves and pedals to take shape.

tulip.dxf

[parrotlady]

Ohhh this is hands down my favorite DXF ever posted!

Thanks, I love it!

April

[ornametals]

wow, thanks, after reading all the personal opinions on "contributing members" i though i need to share more. i wasn't sure i had much to offer becuse i mostly form up items and didn't know if was of use. thanks again

[mdwalker]

wow, thanks, after reading all the personal opinions on "contributing members" i though i need to share more. i wasn't sure i had much to offer becuse i mostly form up items and didn't know if was of use. thanks again

Never second guess what someone else might like. Nice work!

[oldfolks1]

ornametals,
Your Tulip is great, the wife loves it, although I seem to be unable to open your file in any of my programs when I download it.
Any suggestions?

Dan

[ornametals]

i just down loaded it and got nothing i'll try it again in to forms

tulip.pcm

tulip.dxf

[ornametals]

dan, that seemed to work. let me know if it doesn't. not sure if the picture show enough detail but you want to put a slight break in all pieces and roll down. and the pedals, take the first 3 weld to stem. then take 2nd 3, stager and overlap then weld. hope this helps. share photo then built.
russ

[oldfolks1]

Russ,
That file worked fine for me, thanks!

Dan

[plasmajoe]

It does not open for me also, say's invalid DXF drawing discarded. To bad that looks like a good file.

Plasma Joe

[Loyd]

Try this. It would not open for me either. (dxf)
Loyd

[plasmajoe]

Try this. It would not open for me either. (dxf)
Loyd

I worked Loyd thank you. I don't care what everyone says about you, you are a great guy. LOL.

[Loyd]

Well, Loyd has Joe fooled anyway....