![Confused :?](./images/smilies/icon_e_confused.gif)
see the pic comparison ( check the difference in the upper right hand corner of the same part ) and have a look at the .cdr file .............
Thanks, your post prompted me to spend a couple evenings researching the difference between splines and polylines. Learned from that, however, don't think that's my problem. I used the rectangle, ellipse and virtual segment delete tools to draw this up. Cant see that there would be any splines involved ........... unless I'm missing something.tnbndr wrote:I wouldn't be so sure it is Corel. I use Autocad to draw and edit dxf files. I just had this happen the other day in SheetCam also and what I discovered was that the outline of the file was a spline. I traced it and made it a polyline and when imported into Sheetcam all was fine. I don't think Sheetcam likes splines for some reason. Just my conclusion from a single incident.