Got a new table and when I run my g code mach3 doesn't close the relay to start the torch i have the right pins selected and spindle ports setup but it still won't turn on the torch. Also does anyone know what pwm frequecey is or what it does any help is greatly appreciated.
Sgt Joker
-
-
Weekly Free DXF Design
-
Download DXF/SVG
Need help. Mach 3 won't start torch.
-
Sgt Joker
- 1/2 Star Member
- Posts: 6
- Joined: Sun Jun 09, 2013 11:12 am
-
BTA Plasma
- 3.5 Star Elite Contributing Member
- Posts: 626
- Joined: Thu May 12, 2011 4:28 pm
Re: Need help.
Are you in Demo mode or is your software registered?
