I just upgraded to a PM85 when my 1250 started acting funny.... The air solenoid went bad, so I replacced it with a new SMC solenoid. When I hook up the air, the solenoid won't close. When I turn the amperage dial all the way down I can hear the coil clicking on and off, but the air won't shut off. This is the solenoid/valve where the torch plugs in. Any ideas?
Oldsarge
Bad air solenoid on my 1250?
- Oldsarge
- 3.5 Star Member
- Posts: 636
- Joined: Tue Feb 22, 2011 10:12 am
- Location: Lacey, WA
Bad air solenoid on my 1250?
6x12 Home Built Table
Hypertherm PowerMax 85
CandCNC Dragon Cut 620 DTHC IV
CorelDraw X7, Sheetcam, Mach 3
"Better to attempt great things and fail than to live in the gray twilight where there is neither victory or defeat"
Hypertherm PowerMax 85
CandCNC Dragon Cut 620 DTHC IV
CorelDraw X7, Sheetcam, Mach 3
"Better to attempt great things and fail than to live in the gray twilight where there is neither victory or defeat"
-
- 5 Star Elite Contributing Member
- Posts: 3087
- Joined: Mon Jul 20, 2009 11:18 pm
- Location: North Carolina
Re: Bad air solenoid on my 1250?
I would contact Hypertherm tech service.
Jim Colt
Jim Colt
- Oldsarge
- 3.5 Star Member
- Posts: 636
- Joined: Tue Feb 22, 2011 10:12 am
- Location: Lacey, WA
Re: Bad air solenoid on my 1250?
jimcolt wrote:I would contact Hypertherm tech service.
Jim Colt
Thanks, Just called, and Whoa! What's going on? An actual human being of the living breathing type answered the phone!
Yep, consensus is that it's going to take a trip to the shop to see what's going on with it!
Oldsarge
6x12 Home Built Table
Hypertherm PowerMax 85
CandCNC Dragon Cut 620 DTHC IV
CorelDraw X7, Sheetcam, Mach 3
"Better to attempt great things and fail than to live in the gray twilight where there is neither victory or defeat"
Hypertherm PowerMax 85
CandCNC Dragon Cut 620 DTHC IV
CorelDraw X7, Sheetcam, Mach 3
"Better to attempt great things and fail than to live in the gray twilight where there is neither victory or defeat"