Err Message on Dynatorch

[KBMETALWORK]

Dynatorch 5 X 10 table running Version 3.6 software Powermax 85, Draw on Inkscape, G Code made with Sheetcam.
While cutting several pieces out of 11 ga usinf 45 amp fine cut settings, all but one cut out fine.
This one gives me an err of ( Arc center wrong.... check I and J values.... Line #1858 )
How do I correct this?
Can anyone advise me on this?

Thank You
Kenny

[Dawgonhawg]

Kenny, Jim here. Give me a call maybe I can help. I lost your number.