An ideas on how to powder coat both sides of a piece of 14 or 16 gauge about 10x12 inches that has no holes for hanging the piece in the booth or the oven?
Thank for any advice.
No holes for hanging....
-
- 2.5 Star Member
- Posts: 113
- Joined: Sun Jun 03, 2018 2:22 pm
No holes for hanging....
LDR 4'x4' Water Table
Command CNC Linux Controller
Plate Marker
Power Max 45xp w/ Machine Torch & Hand Torch
2 Stage filter, Motorguard filter & HF Ref Dryer
InkScape / SheetCam
Command CNC Linux Controller
Plate Marker
Power Max 45xp w/ Machine Torch & Hand Torch
2 Stage filter, Motorguard filter & HF Ref Dryer
InkScape / SheetCam
-
- 3 Star Member
- Posts: 359
- Joined: Tue Sep 30, 2008 3:40 pm
Re: No holes for hanging....
One side at a time is the only way I think I would do that. Kinda time consuming but gotta charge for that.
- Scratch
- 3.5 Star Elite Contributing Member
- Posts: 811
- Joined: Tue Sep 01, 2009 9:07 pm
- Location: Hudson,WI
- Contact:
Re: No holes for hanging....
Does the back side need to be completely powdercoated? What about a magnet with an eye hook on the back side?
I think I'm the oldest 10 year old boy on the forum...
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7801
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: No holes for hanging....
I saw a post about a guy using a copper tape to powder coat part with no holes, but it still leaves a small place where the tape attached blank when the tape is removed. You may snoop around to find other suppliers.
https://www.ebay.com/itm/Copper-Tape-Co ... Sw4cFd1wx2
https://www.ebay.com/itm/Copper-Tape-Co ... Sw4cFd1wx2
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT