Hello People, I'm looking for idea's on the best way to cover the rails that my bearing ride on, Its a home made table with flat bar for the rails that the stepper motors ride on, I saw somethings on amazon but just looking for different. I just ran a 2500 piece job and the table is a little dirty.
Kenny
Slide covers - Rail covers
-
Welder Kenny
- 2 Star Member
- Posts: 70
- Joined: Wed May 15, 2019 8:12 am
-
adbuch
- 6 Star Elite Contributing Member
- Posts: 8668
- Joined: Thu Sep 21, 2017 5:22 pm
- Location: Tucson, Arizona
- Contact:
Re: Slide covers
Kenny,
My Avid cnc tables use a strip of black teflon type material to cover the linear rails. These strips are about 1/8" thick x 2" wide and run the length of the tables on both sides. Perhaps you could do something similar. Avid uses these for both the cnc router tables and cnc plasma tables.
David
My Avid cnc tables use a strip of black teflon type material to cover the linear rails. These strips are about 1/8" thick x 2" wide and run the length of the tables on both sides. Perhaps you could do something similar. Avid uses these for both the cnc router tables and cnc plasma tables.
David
You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here
-
acourtjester
- 6 Star Elite Contributing Member
- Posts: 7799
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Slide covers
I did see one guy that attached an apron to each slider that extended a distance to each side. This may help if you are using a water table.
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
