Digitize a paper copy of the rubik cube

vancematsalla · Post by **vancematsalla** » Sun Nov 27, 2022 2:45 pm

trace out a paper copy of the rubik cube and cut it out uisng a CO2 laser using logic trace 2022
this is not cut by plasma but could be

https://stankern.vids.io/videos/799fddb ... rubik-cube

: net2.jpg (53.86 KiB) Viewed 750 times

: net1.jpg (53.57 KiB) Viewed 750 times

Post by **Larry83301** » Sun Nov 27, 2022 4:05 pm

Looks neat!

Larry

vancematsalla · Post by **vancematsalla** » Sun Nov 27, 2022 5:13 pm

a 2 d file looking like 3d

Post by **adbuch** » Mon Nov 28, 2022 3:41 am

Nice job Stan! Thanks for sharing. Yes - it definitely looks 3D. It takes a very steady hand to do that tracing like you do with the Calcomp board. I'm not that steady with hand tracing, so I do it with the computer instead. Or use Scanything on my cnc router. What is the make and model of your new laser cutter? I'd like to check it out at the website of the manufacturer.
Thanks,

David

Post by **cuttinparts** » Mon Nov 28, 2022 11:15 am

That's a super cool design. That digitizer is super cool

vancematsalla · Post by **vancematsalla** » Wed Nov 30, 2022 9:08 pm

the laser is dowin but I think they are gone because of covid
my other one is bodor and they should be gone

Digitize a paper copy of the rubik cube

Digitize a paper copy of the rubik cube

Re: digitize a paper copy of the rubik cube

Re: digitize a paper copy of the rubik cube

Re: digitize a paper copy of the rubik cube

Re: Digitize a paper copy of the rubik cube

Re: Digitize a paper copy of the rubik cube