Rampant Lion

[reedcreekwelding]

Hey there folks! I'm looking for a British rampant lion design for a shield. We're on a hereldry kick!

[metalart]

Here's one I did quite awhile ago. Hope it helps

[metalart]

Okay, I'm probably just being a bit cranky at the moment, but after 83 downloads, you would think that at least one person could have said thank you!

[4R8]

Haha, was that your way of thanking?

Cheers for the upload, looks good!

[metalart]

No actually it was my post! That's why I mentioned I might be being a bit cranky! But thanks for the thank you. It's not often that this happens on this site. Most people are very appreciative for the work others submit.

[jhowie]

I have not downloaded the file yet but let me say thank you.
This is such a great site and a lot of you guys and gals go out of your way to help others with whatever it is they may need. I appreciate the community that is here where one can go and ask for help or ideas and get help sometimes almost immediately.
Thanks.

[WSS]

Here is one that I took from this site (cannot remember who to thank!). I did cut it with a family name change, could not find that file, it must be on my table computer, will look manana.

WSS

[WSS]

Found it! It will cut nice w/ Hypertherm fine cut @ 40amp. OOPS, file is too big, PM me of you would like it

WSS

[reedcreekwelding]

Thanks, folks! These are great. I think any one of them will work for our project!

[reedcreekwelding]

Excellent lion...thanks for posting. Will be putting him to good use!