M-16

Post by **DXF** » Tue Mar 13, 2012 3:20 pm

Actually I wasn't planning on posting it until I had a better picture of it. Must have hit the wrong button. Here it is. Does anyone have an old flintlock pistol or rifle they'd share? Thanks

Dave Hanks

larrycameron44 · Post by **larrycameron44** » Tue Mar 13, 2012 3:31 pm

That is a nice M16, are you sharing the dxf or just the picture?

Larry
NZ

wickedinhere · Post by **wickedinhere** » Tue Mar 13, 2012 3:51 pm

Thats nice. DXF file? LOL

Post by **ROCKY** » Tue Mar 13, 2012 6:00 pm

Nice detail..thanks for the file DXF.....Great artwork !!
Its in plasmacam format.

Post by **DXF** » Tue Mar 13, 2012 6:55 pm

ROCKY wrote:Nice detail..thanks for the file DXF.....Great artwork !!
Its in plasmacam format.

Thank you. It really doesn't matter if it's in pcm format because you can import dxf files into Plasma Cam. The reason I post pcm files is to show where I pierced the cuts and most importantly the sequence of the cuts. The pcm cut files are offset .0175" for the .035" kerf width of my plasma cutter and I try to maintain .150" to .200" lead in for each pierce point. I always move around on the cuts and cut all the small ones first. There is a method to my madness! It reduces warpage quite a bit.

Dave Hanks

Post by **Loyd** » Tue Mar 13, 2012 6:59 pm

Try this. Great file by the way....thanks....I have machined thousands of m-16 flash suppressors.... I hate doing production....
Loyd

M16 2.dxf

larrycameron44 · Post by **larrycameron44** » Tue Mar 13, 2012 8:12 pm

Thank you everyone. You know, with all the pictures and dxf files that are posted on here, I have finally paid off my table and compressor.
Still have the AVHC and Powermax 45 to go but I am half way there. yahoo

Larry Cameron
NZ

Post by **Loyd** » Tue Mar 13, 2012 9:17 pm

That's great Larry!
Loyd

RobertJohnson · Post by **RobertJohnson** » Fri Mar 23, 2012 5:08 pm

Thank you! I hope to repay everyone in the near future. Still in the very beginning stages.

AnotherDano · Post by **AnotherDano** » Fri Mar 23, 2012 10:45 pm

RobertJohnson wrote:Thank you! I hope to repay everyone in the near future. Still in the very beginning stages.

Something tells me it will be sooner than you think it will be.
Thanks again for the company and opportunity to yak about the stuff I love to yak about...

Dano

M-16

M-16

Re: M-16

Re: M-16

Re: M-16

Re: M-16

Re: M-16

Re: M-16

Re: M-16

Re: M-16

Re: M-16