Is any one out there using pronest with plasmacam software. I was told you can output to plasmacam from pronest. How does this work and what do I have to do. I am just learning pronest with our new table and was wondering if this can be done and how to go about doing it.(Jim I know you are running a plasmacam also, so if anyone knows I am sure it is you)
Brian
pronest nesting software
-
BrianMick
- 4 Star Elite Contributing Member
- Posts: 999
- Joined: Sun Dec 06, 2009 8:00 am
- Location: St. Cloud,Minnesota United States of America
- Contact:
pronest nesting software
BrianMick
www.midwayiron.com
www.midwayiron.com
-
BrianMick
- 4 Star Elite Contributing Member
- Posts: 999
- Joined: Sun Dec 06, 2009 8:00 am
- Location: St. Cloud,Minnesota United States of America
- Contact:
-
jimcolt
- 5 Star Elite Contributing Member
- Posts: 3087
- Joined: Mon Jul 20, 2009 11:18 pm
- Location: North Carolina
Re: pronest nesting software
Plasma Cam will accept a .dxf file......and I am quite sure that ProNest can output a .dxf file. I am not a ProNest expert....however if you contact the Cam Solutions (formerly MTC Software) they would be happy to assist you with using the ProNest CAM software with your PlasmaCam.
Jim Colt
Jim Colt
BrianMick wrote:Is any one out there using pronest with plasmacam software. I was told you can output to plasmacam from pronest. How does this work and what do I have to do. I am just learning pronest with our new table and was wondering if this can be done and how to go about doing it.(Jim I know you are running a plasmacam also, so if anyone knows I am sure it is you)
Brian
-
shawntravis
- 1/2 Star Member
- Posts: 1
- Joined: Sat Nov 24, 2012 3:35 pm
Re: pronest nesting software
I have a expierence with Pronest. Its an amazing program
