Plasmacam table and Hypertherm Powermax 85 for sale.

[AnthonyCoker]

Asking price 10k. It is DHC2 and as Advanced Machine and Torch Height Control. It has the air Scribe and the router attachments as well with router and vacuum hose. Comes with a Hypertherm Powermmax85. I mainly used the Fine Cut Consumables with it. for 45 amp. It has new grates in it. I will throw in a 80 gallon compressor with it and a whole house vacuum that works with it very well for the router. I am the original owner of it and have some of the paperwork with it. I also have the software and box it comes in. It runs and you can see it with your own eyes.

[adbuch]

Adding photos, a description of exactly what Design Edge software upgrades you have (screen shot of Settings, Activate Levels page), as well as your asking price would go a long way towards actually finding a buyer for your setup.

Thanks,
David

[AnthonyCoker]

Sorry still learning how to post in here. I updated it.

[adbuch]

Sorry still learning how to post in here. I updated it.

[AnthonyCoker]

The price wasn't firm but needed a starting point. If you need more pics or info on it message me. I have no problem. I can give phone number and it is located in Temple GA.