Help with upsidedown cutting with Torchmate
- tentonjj
- 2.5 Star Elite Contributing Member
- Posts: 216
- Joined: Fri Nov 14, 2008 8:57 pm
Help with upsidedown cutting with Torchmate
Helo all, I've been here for a little while and found some useful info on here. I have an issue with our torchmate software. When I load it into Torchmate 3 to cut the steel, it always cuts it upside down on the plasma table leaving large slag on the feature side of the piece. I hate using the grider cause it leaves such deep grooves. If I reverse the drawing the same thing happens. Any advice would be great!!!!
Jayson Johnson
JMJ Graphix
920-517-7122
JMJ Graphix
920-517-7122
-
- 2 Star Elite Contributing Member
- Posts: 66
- Joined: Thu Jun 25, 2009 7:48 am
Re: Help with upsidedown cutting with Torchmate
For my software i use coral draw and then send it to comand and cut. Both have a tool bar at the top of the screen that says mirror.this will flip your drawing over.
Hope this works Jim(murals in metal)
Hope this works Jim(murals in metal)