Hello
I have been told that my Torchmate 2 table moves to slowly for decent cutting on thin material. I have worked following the Torchmate instructions on setting up the axis speeds and accelerations. What speeds and accelerations are the rest of you Torchmate users getting? I can get about 160ipm axis speed and 15ips^2 acceleration before I loose steps.
John
Axis Speeds
- modelaratrod
- 2 Star Member
- Posts: 86
- Joined: Tue Jul 23, 2013 12:41 pm
- Location: Colorado
Re: Axis Speeds
Hey John sorry I didn't see this post earlier, with the upgrades you helped me with I can run 150 to 160 pretty reliably.
5x10 Torchmate 2 w/AVHC
Hypertherm PM85 w/ machine & hand torch.
Hypertherm PM85 w/ machine & hand torch.