Recent Samson 510 CNC projects

[Joe Jones]

I haven't hooked my plasma cutter to my plasma table YET. I am having too much fun with the router!

[PlasmaMac]

Awesome work Joe!
It is amazing seeing all of the different things that one can do with the plasmacam, besides just plasma.

Keep us posted, Brother!

JAG

[Joe Jones]

[PlasmaMac]

You did that with the router on your plasmacam?
That's off the wall, Brother!!

Just makes me wonder what's next?

[Joe Jones]

I haven't hooked up the plasma cutter yet. I am having too much fun using a router on the table.

I am wandering into "barn quilts" and optical illusions next. For now, I am playing with halftone images and 3D carving, etc.

[Joe Jones]

You did that with the router on your plasmacam?
That's off the wall, Brother!!

Just makes me wonder what's next?

Actually PlasmaCam's big brother, the Samson 510 table using a Bosch 2.25HP router and a V-groove bit for most of it. The "Willowtree" sign was in a maple plank, using a 1/8" two-fluted bit with a flat bottom, and an adapter sleeve for the router which normally accepts 1/2" shank router bits. The 3D carving was done with a 1/8" round nose two-flute bit.

On this clock face, I need to adjust the cut path to allow for a wider rib holding the centers of the numbers, along with making the centers larger.

[Joe Jones]

Do you think people would order these for their homes?

I could sell them for $199.00 + shipping.

Green display base not included. Actual side posts are 10" longer, to be sunk into ground.

(Some Assembly Required )

[motoguy]

Neat. I'm looking to use the additional capabilities of my Bulltear/Starlab table as well.

[Joe Jones]

Neat. I'm looking to use the additional capabilities of my Bulltear/Starlab table as well.

Do it! There is nothing more reassuring about your purchase, than to do more with your table than it's design intent.

Post photos!




.