What concentration of muriatic acid do you use to remove dross.
Thanks
Rick
Muriatic Acid consentration
- little blue choo
- 4 Star Member
- Posts: 1461
- Joined: Mon Mar 02, 2015 10:38 pm
- Location: Cherryville NC
- Contact:
Muriatic Acid consentration
Rick
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape
-
- 2 Star Elite Contributing Member
- Posts: 99
- Joined: Fri Jul 05, 2013 11:18 pm
- Location: Concord NC
- Contact:
Re: Muriatic Acid consentration
I use 1:1.5 to 1:2 acid to water. This is just an estimate. I don't measure
- little blue choo
- 4 Star Member
- Posts: 1461
- Joined: Mon Mar 02, 2015 10:38 pm
- Location: Cherryville NC
- Contact:
Re: Muriatic Acid consentration
What I was looking at was like 32% or something like that. So you then cut the 32% stuff 1 part acid to 1.5 part water. Is this right?
Thanks
Rick
Thanks
Rick
Rick
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape