Plasma cam 4x4 table grates

Post by **kenny** » Thu Jul 21, 2016 10:21 am

Does anyone have plans cut paths for plasma cams 4x4 table grates.
Thank you

PlasmaMac · Post by **PlasmaMac** » Fri Jul 22, 2016 7:04 pm

You might take a look within plasmacam online owners community. Lots plasmacam owners on there that could help out. You can also easily order a set at the same place from plasmacam.

Good Luck Brother,

JAG

Post by **tnbndr** » Sat Jul 23, 2016 7:10 am

Did you look at the first thread on the Plasma CAM section??

http://plasmaspider.com/viewtopic.php?f=61&t=2272

Amyfreestone · Post by **Amyfreestone** » Thu Sep 01, 2016 12:52 am

Grate.zip

Post by **Ironman** » Mon Oct 10, 2016 12:50 pm

kenny wrote:Does anyone have plans cut paths for plasma cams 4x4 table grates.
Thank you

Here are mine. These are for a grate made of 1.5 x 1/8" flat bar and the center slots for the flat bar are offset an inch to give it a curve. This keeps it snug in the slots, and means if you cross a line you won't burn down the whole length. Also ends most tip ups.

Binderman01 · Post by **Binderman01** » Tue Dec 27, 2016 8:27 pm

Im coming to a mental block looking at your drawing Ironman. What are the 4ft. pieces that are sunk down with only 3 slots for? got a picture of your setup?

Plasma cam 4x4 table grates

Plasma cam 4x4 table grates

Re: Plasma cam 4x4 table grates

Re: Plasma cam 4x4 table grates

Re: Plasma cam 4x4 table grates

Re: Plasma cam 4x4 table grates

Re: Plasma cam 4x4 table grates