What Post Processor - CandCNC?

whiskeymike · Post by **whiskeymike** » Mon Oct 17, 2016 10:19 am

What post processor are you running with a CandCNC DTHC IV setup? I noticed that DTHC_HYT_TAP_Softpierces+marker Rev 11J is the latest on the download page back from this time last year. But I've seen mention of folks running Rev 16, and various others.

Where should I get the latest stable version with the best features?

exapprentice · Post by **exapprentice** » Mon Oct 17, 2016 1:05 pm

“CandCNCPlasmaRev11M1” Used for the quick torch off feature

Post by **acourtjester** » Mon Oct 17, 2016 2:24 pm

11m1 does not show up on their web site??????
Is that only for eithercut versions??????

WyoGreen · Post by **WyoGreen** » Mon Oct 17, 2016 8:14 pm

When Rev 16 is mentioned, that is a Post for the Linux version. I'm thinking that the 11m post is in the

"Support Files Latest SheetCAM TNG (version 6.0.1 or later) with DCC upgrade Includes new POST files, Hypertherm 45 thru 105 Cut Profiles (tooltables) Updated 06/10/2015" selection.

Not positive, just thinking it may be. Steve

Corfabrication · Post by **Corfabrication** » Wed Jan 18, 2017 9:30 pm

exapprentice wrote:“CandCNCPlasmaRev11M1” Used for the quick torch off feature

for real?

exapprentice · Post by **exapprentice** » Sun Jan 29, 2017 5:40 am

The post I mentioned above
is for the Mach/ethercut version only
But I am now just starting the process of changing over to CandCNC's Linux system from my ethercut setup

What Post Processor - CandCNC?

What Post Processor - CandCNC?

Re: What Post Processor - CandCNC?

Re: What Post Processor - CandCNC?

Re: What Post Processor - CandCNC?

Re: What Post Processor - CandCNC?

Re: What Post Processor - CandCNC?