Plasmacam Height

Jspece · Post by **Jspece** » Wed Dec 20, 2017 9:52 pm

What is the physical height to the highest point of the cable holder on a plasma cam? Is there any adjustment to it? Interested in a 4x4 unit but my shop has a low cieling.

Post by **Francisco** » Thu Dec 21, 2017 3:02 pm

About 90" / 2.3 m

There's no adjustment, per se. You could modify the setup to make it a little shorter, I guess, but not much. You may end up with either a) the cables dragging or b) losing some cutting area.

Post by **rdj357** » Thu Dec 21, 2017 3:53 pm

I cut mine off about a foot to allow for clearance to my gantry crane. Works fine.

Jspece · Post by **Jspece** » Thu Dec 21, 2017 4:51 pm

90" really? I'm 1 inch short lol

Rex · Post by **Rex** » Fri Dec 22, 2017 1:14 am

I drilled new holes and drop it 5 inch,
Works fine

Plasmacam Height

Plasmacam Height

Re: Plasmacam Height

Re: Plasmacam Height

Re: Plasmacam Height

Re: Plasmacam Height