Ezcut stalled.

Voesenekcnc · Post by **Voesenekcnc** » Sun Apr 01, 2018 7:41 pm

Machine sparks up and won’t move on to cut pattern. Just blows hole. Help?

Voesenekcnc · Post by **Voesenekcnc** » Mon Apr 02, 2018 8:51 pm

Voesenekcnc wrote:Machine sparks up and won’t move on to cut pattern. Just blows hole. Help?

has anyone had this problem or know what we can do to fix it ??

larrycameron44 · Post by **larrycameron44** » Tue Apr 03, 2018 4:45 am

I think to answer your question we need more info.
Machine
Plasma cutter
Software
Settings etc

Larry Cameron
RusticMetalArt

waldner33 · Post by **waldner33** » Fri Apr 13, 2018 11:57 pm

Yes the small board where the powmax or plasma cutter plugs in has 2 small relays on it replace board .
It dosnt get the ok to move signal

waldner33 · Post by **waldner33** » Fri Apr 13, 2018 11:58 pm

On the control of the machine not the cutting unit