Hypertherm 600 and 3/8ths hr

AIRFLOWKID · Post by **AIRFLOWKID** » Sun Mar 20, 2011 9:22 pm

Jim,
I have a hypertherm 600. I am going to be cutting out some crosses using 3/8ths hr. I'm I O.K. with fine cut or should I switch?

Thanks so much, Tim A Reamer
DHC
Hypertherm 600

jimcolt · Post by **jimcolt** » Sun Mar 20, 2011 10:53 pm

The maximum thickness that the FineCut consumables should be used for is 1/8".....for 3/8" use the 40 amp shielded consumables.

Jim Colt

AIRFLOWKID · Post by **AIRFLOWKID** » Mon Mar 21, 2011 11:36 am

Thanks Jim

Sincerely,
Tim Reamer

Hypertherm 600 and 3/8ths hr

Hypertherm 600 and 3/8ths hr

Re: Hypertherm 600 and 3/8ths hr

Re: Hypertherm 600 and 3/8ths hr