Controller , very sad :(

Ian Davis · Post by **Ian Davis** » Wed Jul 22, 2020 7:31 am

Does anyone know of a source of a very cheap Samson 510 plasmacam controller ? I have just reassemble my table as I finally got some work for it .and put the controller in the computer cab . It must have been removed before I took my table , to its new home . I am up the creek really . If not would anyone be interested in it who could afford to buy the controller. Thank you . Ian .

Ian Davis · Post by **Ian Davis** » Wed Jul 22, 2020 7:44 am

BTW . i am UK based .

Post by **adbuch** » Wed Jul 22, 2020 8:21 am

You could probably get this one really cheap, although it may need some repair or troubleshooting.
David

viewtopic.php?f=57&t=30520

Ian Davis · Post by **Ian Davis** » Wed Jul 22, 2020 9:06 am

Thank you . I see they are not listed on the site anymore .

Post by **adbuch** » Fri Jul 24, 2020 6:49 am

Ian,
I feel your pain. I'll keep my eyes out for a used controller for you. I'd hate to see you convert to stepper motors.
David

Controller , very sad :(

Controller , very sad :(

Re: Controller , very sad :(

Re: Controller , very sad :(

Re: Controller , very sad :(

Re: Controller , very sad :(