Few Questions:
Is this normal Top Dross at a Pierce?
DTHC Delay (sec) or Auto? Does any one prefer one setting to the other or what is the best way using this? Still trying to grasp operations on these.
![Smile :)](./images/smilies/icon_e_smile.gif)
And last. Two times my torch stopped just after finishing a hole or inside shape. I usually do an Arc Lead In and Lead Out and also added additional .25 over cut. Trying to smooth out start and stop points. I have the Rule applied slow 60% on small circles. Holes start in center . Im cutting 1/4" 45A Used .25 Arc lead in and went longer on my lead out .26 with .25 overcut.
Basically at my pierce point I have a bit of material still hanging.
Is my Pierce too close or too far?
Awe so many questions!
thanks in advance