Tig torch holder

Post by **Dirtmotor** » Sun Apr 28, 2024 3:24 pm

Here is one I made , I found on this site but cannot seem to find again ,Thanks to the

torch holder.jpg

torch holder 2.jpg

OP for design I just added a peg to fit in table .

Post by **acourtjester** » Sun Apr 28, 2024 9:21 pm

Looks like it is very portable, nice

Post by **tinspark** » Fri May 10, 2024 2:43 pm

I like it!
especially for the fact that you can pull it out of a hole and drop it in anywhere down the line.

Post by **adbuch** » Fri May 10, 2024 5:10 pm

I like it as well. I asked Admin to see if he could find the original file, but no luck. Perhaps we could draw up a similar file from scratch.

David

Post by **Dirtmotor** » Fri May 10, 2024 8:53 pm

tig torchholder.svg

Here is what I have

Post by **Dirtmotor** » Fri May 10, 2024 9:03 pm

torch holder.svg

from inkscape

Post by **adbuch** » Fri May 10, 2024 9:59 pm

tig torch holder dxf image.jpg

tig torch holder.dxf

Post by **adbuch** » Fri May 10, 2024 9:59 pm

Dirtmotor wrote: Fri May 10, 2024 8:53 pm tig torchholder.svg
Here is what I have

Thanks!!
David

Post by **tinspark** » Sat May 11, 2024 2:40 am

adbuch wrote: Fri May 10, 2024 9:59 pm tig torch holder dxf image.jpg
tig torch holder.dxf

Nice work David! Thank you..