DFX file

[chubbymoney84]

Hello guys my user name is chubby money, but my real name is justin i’m from Buffalo New York and I’m looking for a DFX file of a front loader grapple for my sub compact tractor I also have a plasma cutter crossfire bro I had a little over a year now are you make a lot of things for it I probably could make the gravel it is not the best at drawing getting better person myself but if anybody has one to share I’d really appreciate it maybe you’ll like that and I have been I could share that with you I make a lot of art And signs and these pockets for a quick equipment trailers so you can hook rip them register traps with the heavy duty registrants to them and make them pockets. Thunder pockets. I got a couple different ideas thanks let me know everybody God bless.

[DieselFumes]

Hey chubbymoney, I found these when I was looking to do the same

https://www.plasmaspider.com/viewtopic. ... 47#p145947
https://www.plasmaspider.com/viewtopic. ... 464#p50464

To download these though you have to be a contributing member...best $20 you will ever spend

[jmersereau]

I cleaned up the first linked dxf that was for the 50" grapple. When I first tried to open it, it was all unlinked line segments.

50 inch Grapple.png

50 inch Grapple.dxf

Grapple Notes.png

[adbuch]

Jim - I opened your dxf file to take a look. I did not check out the original file you started with. Perhaps your file would cut fine, except for that square in the middle. In any case, Design Edge shows the following intersections.

36 intersectons.jpg

This is what it look like after linking/joining with Design Edge. I went ahead and posted the edited file below.
Thanks for your efforts!!
David

0 intersectons.jpg

50 inch Grapple linked.dxf