Motion pauses randomly on straight sections

[acourtjester]

I have been working with another DIY guy on some problems with his start up. His table is cutting now but it has a odd movement problem and I cannot come up with an answer. It looks like a mechanical problem but does it in the X and Y directions, not like slipping. When cutting is seems to pause while cutting a straight line. The video shows cutting a rectangle and it pauses on the 4 side cuts, not when changing directions!!!!
Any theories??

IMG_2673.mp4

[Joe Jones]

It sounds like you are cutting four individual paths, rather than a single closed path.

Joe

[acourtjester]

Forget it he said he reloaded Mach and it now does not pause. This remote troubleshooting has its limits, he is far way from me.

[adbuch]

Forget it he said he reloaded Mach and it now does not pause. This remote troubleshooting has its limits, he is far way from me.

Great effort on your part Tom!! Happy to hear he is up and cutting again.
David

[acourtjester]

Thanks happy to help, keeps the old gray matter active.