Hello from Oklahoma

Post by **BGHotrodshop** » Sat Jan 04, 2025 10:01 pm

New member from Oklahoma.
Just bought a new Langmuir CF Pro.
Had the original table a few yrs ago and sold it. Got aggravated at learning the programming.
Decided to try again. Found lots of new helpful information so far including this site.
I build Hotrods and ratrods as a hobby and this table will come in very handy.

Post by **adbuch** » Sat Jan 04, 2025 10:09 pm

Welcome aboard BG! Congratulations on acquiring your new table. Langmuir has some great Fusion 360 tutorial videos, which is what I think most of the Langmuir table owners use. If you decide to go with something different like Inkscape/SheetCam - I believe there are SheetCam post processors available for your controller as well. Let us know if you have any questions about any of this.

David

Post by **BGHotrodshop** » Sat Jan 04, 2025 10:18 pm

adbuch wrote: Sat Jan 04, 2025 10:09 pm Welcome aboard BG! Congratulations on acquiring your new table. Langmuir has some great Fusion 360 tutorial videos, which is what I think most of the Langmuir table owners use. If you decide to go with something different like Inkscape/SheetCam - I believe there are SheetCam post processors available for your controller as well. Let us know if you have any questions about any of this.

David

Thank you
Yes, I have been all through the Langmuir videos and some on YouTube as well. My wife uses Inkscape a lot with her shirts and tumblers so I have help with that. I am using Fusion currently but have Sheetcam as well to dig into at some point.

Post by **adbuch** » Sat Jan 04, 2025 10:23 pm

Fusion 360 should work fine for simple parts and brackets. For more artistic/complex files, I have found that SheetCam is much faster than trying to fight with Fusion 360 hang-ups and very slow cut path generation.

David

Hello from Oklahoma

Hello from Oklahoma

Re: Hello from Oklahoma

Re: Hello from Oklahoma

Re: Hello from Oklahoma