Conch Shell

Post by **Copp3r** » Sun Dec 11, 2011 8:33 pm

For the sailor in all of us.... Have a peek at this conch shell.

Cheers !

Copp3r / Roger

Conch Shell #1.dxf

Platt Mfg · Post by **Platt Mfg** » Sun Dec 11, 2011 11:28 pm

love it thanks for the file

WSS · Post by **WSS** » Mon Dec 12, 2011 12:11 am

Awesome! THX!!

WSS

bwgsmith · Post by **bwgsmith** » Mon Dec 12, 2011 9:57 am

Nice job thanks for sharing.

Zippo · Post by **Zippo** » Mon Dec 12, 2011 10:00 am

nice, thanks for sharing

Post by **RClippa** » Mon Dec 12, 2011 10:23 am

Thanks, my mom will love this one.

metalart · Post by **metalart** » Mon Dec 12, 2011 10:49 am

Thanks for sharing - can you post the pcm as a older version?

Post by **Copp3r** » Tue Dec 13, 2011 3:34 pm

PCM older version? I'm currently using Design Edge and I'm guessing you're wondering if I can save to a previous software version. Hmm? Good question.

The DXF file should cover you off. If not, let me know and I'll have a peek and see if I can figure anything out.

(download the DXF and then use Import and you should be good to go... set up your own cut paths, size, etc.)

Copp3r / Roger

metalart · Post by **metalart** » Tue Dec 13, 2011 8:26 pm

That's what I usually do, I was just wondering if the pcm could be saved as an older version or not? Just curiosity and sometimes a bit of laziness on my part possibly?

Conch Shell

Conch Shell

Re: Conch Shell

Re: Conch Shell

Re: Conch Shell

Re: Conch Shell

Re: Conch Shell

Re: Conch Shell

Re: Conch Shell

Re: Conch Shell