SheetCAM length of cut.

Post by **crowdog** » Thu Dec 22, 2011 4:01 pm

Does SheetCAM have a length of cut feature that I am missing? Or just multiply the simulation time (converting seconds to decimal minutes) times the cut speed, the way I have been doing it?

Thanks,
Crowdog

4R8 · Post by **4R8** » Thu Dec 22, 2011 5:55 pm

I don't have the computer with sheetcam nearby but for memory
once you've imported your file and set your project up as wanted, go to file - then it's something like "job report"
This gives number of pierces as well as cut inches and plenty of other info on the project

I Lean · Post by **I Lean** » Thu Dec 22, 2011 8:49 pm

Yep, "Job Report". It's also an icon at the top that looks like a sheet of paper.

Post by **crowdog** » Sat Dec 24, 2011 11:12 pm

Hadn't seen or tried that yet,

Thanks,
Crowdog

SheetCAM length of cut.

SheetCAM length of cut.

Re: SheetCAM length of cut.

Re: SheetCAM length of cut.

Re: SheetCAM length of cut.