DXF opens but nowhere near PCam table

Post by **plascutart** » Mon Mar 25, 2013 2:04 am

Hi, I had a file sent to me, it opens in plasma cam, but I cannot find cutting area of table.
any ideas.
I have attached the file, if someone could open in plasma cam, save & send back or post it please

regards
plascutart

Craig · Post by **Craig** » Mon Mar 25, 2013 2:22 am

Plascutart, the table is there, it is lower left and is a light blue dot when zoomed out. Craig Johnson

Post by **plascutart** » Mon Mar 25, 2013 7:22 am

I must be doing something wrong then, cause I cannot get to the table in a size I can see.
plascutart

Post by **Stout** » Mon Mar 25, 2013 7:27 am

It seems to open fine in CorelDraw X6. There's a grid in green and a rectangular shape just below it.

Post by **plascutart** » Mon Mar 25, 2013 8:54 am

I got it, I used the mouse co ordinates from the table, then opened the drg, it was 30 meters or 90ft away from the table. kept moving the drg. in the direction of table co ordinate until table came into view.
thank you guys for your help
plascutart

Post by **BrianMick** » Mon Mar 25, 2013 10:38 am

Next time this happens, select the object, select "move"(quick key is M in designedge) click the object, select zoom to table(F7 is quick key in designedge) and it will move the object to the table......This is very handy...I get files drawn by customers that are out in no-mans land all of the time
Brian

DXF opens but nowhere near PCam table

DXF opens but nowhere near PCam table

Re: DXF opens but nowhere near PCam table

Re: DXF opens but nowhere near PCam table

Re: DXF opens but nowhere near PCam table

Re: DXF opens but nowhere near PCam table

Re: DXF opens but nowhere near PCam table