burntables w/ thermal dynamics plasma help

Thermal Dynamics plasma cutter discussion forum.
Post Reply
Coffinscreekcustoms
2.5 Star Member
2.5 Star Member
Posts: 114
Joined: Mon Apr 23, 2012 10:44 pm
Location: Masonville IA
Contact:

burntables w/ thermal dynamics plasma help

Post by Coffinscreekcustoms »

Hello y'all I just got my box back from getting serviced and like a dumb@$$ I didn't mark my wires to get hooked back up! So questions are the two wires coming out of my torch box one is connected to the positive lead and one to the ground
So would the one connected to the positive be torch - and the one from the ground be connected to table +? Really appreciate any help I can't get ahold of kyle or matt ...
Thanks jake
jimcolt
5 Star Elite Contributing Member
5 Star Elite Contributing Member
Posts: 3087
Joined: Mon Jul 20, 2009 11:18 pm
Location: North Carolina

Re: burntables w/ thermal dynamics plasma help

Post by jimcolt »

Work ground clamp is always positive with plasma cutters, torch electrode is always negative.

Jim Colt Hypertherm

Coffinscreekcustoms wrote:Hello y'all I just got my box back from getting serviced and like a dumb@$$ I didn't mark my wires to get hooked back up! So questions are the two wires coming out of my torch box one is connected to the positive lead and one to the ground
So would the one connected to the positive be torch - and the one from the ground be connected to table +? Really appreciate any help I can't get ahold of kyle or matt ...
Thanks jake
Coffinscreekcustoms
2.5 Star Member
2.5 Star Member
Posts: 114
Joined: Mon Apr 23, 2012 10:44 pm
Location: Masonville IA
Contact:

Re: burntables w/ thermal dynamics plasma help

Post by Coffinscreekcustoms »

Thanks so much!!!
Post Reply

Return to “Thermal Dynamics / Esab Plasma Cutters”