spinners

Post by **wislerster** » Sat Jul 24, 2010 12:44 pm

Here are 2 spinners I made, did not draw the sedond one. Downloaded from this site "LOVE THIS SITE". The first on I made for my company.

Post by **Disturbed** » Fri Aug 20, 2010 3:49 pm

I have seen these all overthis site. I have a question, what thickness steel are you cutting these out of andmore importantly how do you twist them?

My parents own a Christmas tree farm and I would like to make some of these with winter/Christmas themes but I am not sure how you guys twist them....and I still dont have my plasma table running.

Post by **mdwalker** » Fri Aug 20, 2010 6:06 pm

Disturbed wrote:I have seen these all overthis site. I have a question, what thickness steel are you cutting these out of andmore importantly how do you twist them?

My parents own a Christmas tree farm and I would like to make some of these with winter/Christmas themes but I am not sure how you guys twist them....and I still dont have my plasma table running.

The ones I have cut have been out of 16ga. They are very easy to twist by hand.

Danny

spinners

spinners

Re: spinners

Re: spinners