New here

[JK Fab]

Hello ladies and gentlemen. I am a structural steel fabricator by trade. Couple of decades in. I have for my personal shop a 4x4 star labs table with a pm45. At work I occasionally run a Messer 10x25 that will pierce 1 1/2” on the plasma and do 12” on the oxy/fuel. Structural plate has a ton of drop so if you are looking for a few small parts your equipment can’t do, hit me up. Other than that I’m looking forward to sharing some dxf’s and cutting some iron.

[Scratch]

Welcome to the forum!