Hello from Chester, UK

spanners101 · Post by **spanners101** » Fri Sep 20, 2019 7:49 am

Hello.

Pleased I've found this community! Hopefully I can contribute as well as asking for advice from you all:)

I run a 2x4 machine made by a uk company mainly for creative/ sculpture projects. Still ironing out some issues. Previously ran Swiftcut machine/ Hypertherm for a living. Running my own machine has been a challenge!

Post by **plasmanewbie** » Wed Sep 25, 2019 9:47 am

Welcome to the site! It is a bit of a challenge in many ways but well worth it. Best of luck

Post by **robertspark** » Wed Sep 25, 2019 10:47 am

hello and welcome, just up the road / over the water from you nr liverpool

spanners101 · Post by **spanners101** » Wed Sep 25, 2019 12:33 pm

Oh, cool! I don't know anybody who else who crazy enough to do this:) I have a setup in a shed in the garden. Not ideal. nice to know there is someone nearby

Post by **robertspark** » Wed Sep 25, 2019 1:13 pm

there are quite a few. shed is hard going. all the hot works I do I wouldn't be too keen on a shed but needs must...had some fun after heavy angle grinding to shape and had something covered over with a cotton (lint type) dust sheet behind the workmate I use once

... make sure I stop hot works 30mins before I leave the area just in case something is still smouldering unseen

spanners101 · Post by **spanners101** » Wed Sep 25, 2019 2:01 pm

I plasma in a metal shed, and grind, fab, weld etc. in a friend's garage. One day I'll have a workshop:)

Hello from Chester, UK

Hello from Chester, UK

Re: Hello from Chester, UK

Re: Hello from Chester, UK

Re: Hello from Chester, UK

Re: Hello from Chester, UK

Re: Hello from Chester, UK