Hello all

[mikel]

My name is Mike I have been building and restoring custom cars for thirty years finally have the opportunity to operate a plasma table.
The shop has gotten a truCut table and I would love to figure out how to use it.
I understand the mechanics of it but the computer side is all new to me and I am hoping I can find some directions on where to get the best info on the basics.
Everyone I have talked to says this is the place to follow to learn about how to use the machine.
I hope I don't ask tooo many really stupid questions and that I am not actually to old to learn how to do this.
Thanks for any help in advance
Mike

[weldguy]

Hey Mike, welcome to the site. Pick a simple project to start with and if you questions just ask. Plenty of help here. Best of luck