I'm currently in the process of building my own plasma table. A 4x6 using VEXTA 5-phase motors and drives. I'm still a long ways off, but I hope to be there soon.
newbie - Building own Table
-
hammerswan
- 1/2 Star Member
- Posts: 1
- Joined: Mon Jan 31, 2011 1:12 pm
newbie - Building own Table
Hi, I'm new to this forum. I'm really looking forward to seeing what the community is all about here.
I'm currently in the process of building my own plasma table. A 4x6 using VEXTA 5-phase motors and drives. I'm still a long ways off, but I hope to be there soon.
I'm currently in the process of building my own plasma table. A 4x6 using VEXTA 5-phase motors and drives. I'm still a long ways off, but I hope to be there soon.
-
jeeplogic83
- 2.5 Star Member
- Posts: 154
- Joined: Fri Nov 14, 2008 6:52 am
- Location: West MI
- Contact:
-
admin
- Site Admin
- Posts: 362
- Joined: Thu Jul 03, 2008 5:12 pm
- Location: Out In The Shop
- Contact:
Re: newbie
Welcome to the site, I am confident you will find it to be very helpful and amusing. Best of luck with your build! Would like to see it when it's done.
-
plasmajoe
- 3.5 Star Elite Contributing Member
- Posts: 675
- Joined: Thu Jul 30, 2009 8:19 pm
Re: newbie
Welcome aboard, you will find this site quite helpful and resoursful. Need advice or help just ask you will be surprised at what you recieve in return, the guys and gals on here are quite open to help you out.
Plasma Joe
Plasma Joe
