Bar Sign

larrycameron44 · Post by **larrycameron44** » Mon Jan 16, 2012 2:41 pm

These signs were made by David Reid from Aussie who sent them to me to post as he is having computer upload problems.
It was sent in a CDL so I did the quick toolpathing on it.

Cheers

Larry

Post by **DXF** » Mon Jan 16, 2012 3:24 pm

Thanks, those are cool! Do you have them in a dxf format without the pierce points? I know beggars shouldn't be choosers but I'm not sure if you offset the file for kerf width or not when you created the pierce points. Thanks again.

Dave Hanks

bwgsmith · Post by **bwgsmith** » Mon Jan 16, 2012 3:58 pm

Thanks for posting.

Post by **Larry83301** » Mon Jan 16, 2012 4:40 pm

DXF wrote:Thanks, those are cool! Do you have them in a dxf format without the pierce points? I know beggars shouldn't be choosers but I'm not sure if you offset the file for kerf width or not when you created the pierce points. Thanks again.

Dave Hanks

Thought I'd help out a little. Nice files!

Larry

Post by **Charlene** » Mon Jan 16, 2012 6:39 pm

Thanks guys!

Post by **stdave66** » Mon Jan 16, 2012 8:00 pm

Thanks!!!

Zippo · Post by **Zippo** » Mon Jan 16, 2012 10:03 pm

real nice signs, thanks for sharing

reidy01 · Post by **reidy01** » Mon Jan 23, 2012 9:19 pm

I've been trying to give back for ages but couldn't seem to up load as much as tried, but hey I hope someone somewhere can use them. Thanks very much for doing that for me Larry, I owe you a beer.

Bar Sign

Bar Sign

Re: Bar Sign

Re: Bar Sign

Re: Bar Sign

Re: Bar Sign

Re: Bar Sign

Re: Bar Sign

Re: Bar Sign