Cutmaster 101 with sl100 table

Big10ton · Post by **Big10ton** » Tue Oct 06, 2020 11:43 am

I'm new to this and came across this cutmaster 101 with sl100 table which wires do you hook up to the cnc control box to make it fire without having to jumper it. Also running air if that helps. Any honest answers will be greatly appreciated thanks

Post by **weldguy** » Wed Oct 07, 2020 9:42 am

If you are making it fire with a jumper those 2 wires your jumping would be the 2 wires you would hook up to your cnc controller.

Big10ton · Post by **Big10ton** » Wed Oct 07, 2020 6:00 pm

Ok thanks. I also have a bad relay when I tried to ohm it out it wouldn't so I ordered another one. Thanks for the input on the wiring

Post by **weldguy** » Thu Oct 08, 2020 11:51 am

Your welcome, and good luck

Big10ton · Post by **Big10ton** » Wed Oct 14, 2020 12:11 pm

I replaced the red relay and can jumper the first 2 legs on the plasma start to get it to fire but which wires go to the arc transfer pins. Any and all help would be appreciated Thanks in advance

Cutmaster 101 with sl100 table

Cutmaster 101 with sl100 table

Re: Cutmaster 101 with sl100 table

Re: Cutmaster 101 with sl100 table

Re: Cutmaster 101 with sl100 table

Re: Cutmaster 101 with sl100 table