Lead Ins & Start Points

[Charlene]

Alright, I imported this file into Sheetcam and everything was reversed. The lead ins are on the outside when they should be on the inside, cutting in the wrong direction, etc. It was created in CorelDraw x5. I have tried simply clicking on the "Reverse Cut Direction" but I can't get the lead-ins to change sides.

Any help would be greatly appreciated!

[muzza]

Charlene,
In Sheetcam go down to Operations, then on Contour Method change offset from outside to inside or visa versa
Murray

[Charlene]

Thanks Mirth, I will give that I try.

[trucks1948]

I also use corel x5 and when i import into sheetcam ever so often it changes the lead ins from inside top out.